52
6 Network Print Monitor
Preparation
The print server supports TCP/IP, IPX/SPX and NetBEUI protocols under Microsoft
Windows system. Please make sure that the following steps have been completed before
proceeding with installation under Microsoft Windows 95/98/ME/NT4/2000/XP 32bit edition
or server 2003 32bit edition.
Select A Desired Protocol
TCP/IP
The TCP/IP Protocol must be installed. For further information, please read “TCP/IP
Protocol Installation” section in this chapter.
Note: If TCP/IP protocol is chosen, please refer to “Assigning an IP Address to the print
server” section later in this chapter.
IPX/SPX
The IPX/SPX-compatible Protocol must be installed. For further information, please read
“IPX/SPX-compatible Protocol Installation” section in this chapter.
NetBEUI (Windows 9x/ME/NT4/2000)
The NetBEUI protocol must be installed. For further information, please read “NetBEUI
Protocol Installation” section in this chapter. The Microsoft Windows XP/2003/Vista/7 does
not support the NetBEUI printing.
TCP/IP Protocol Installation
1. Click Start, point to Settings and select Control Panel.
2. Double click the Network icon.
3. If the TCP/IP Protocol is not already installed, click Add.
4. Select Protocol and click Add.
5. Select Microsoft from the Manufacturers list.
6. Select TCP/IP Protocol from the Network Protocols list.
7. Specify an IP address, Subnet Mask, and Gateway address or specific “Obtain IP
address automatically”, if a DHCP server is available on the LAN.
8. Restart the computer.
9. Done.
To Next Page
Loading...
Need help?
General
