To Previous Page

Question D

The Status LED light keeps blinking after POST.

Possible explanation and solution

The last upgrade process was not completed. The print server must be upgraded again by

using the PSAdmin. Please see Chapter 3 for details.

Question E

The PSAdmin reports “Create Print server Error”, “Create Printer Error”, or “Create Print

Queue Error” while using Auto Setup.

Possible Explanation

The print server name, the printer name, or the print queue name you specified in the Auto

Setup dialogue box contains a space.

Solution

Check to see if there is a space in the print server name, the printer name, or the queue

name. Type in a new name without a space between two characters or replace a space by

a dash (-) or an underscore (_).

Question F

The PSAdmin reports “Print server Already Exists”, “Printer Already Exists”, or “Print Queue

Already Exists” after specifying the print server name, or the print queue name in Auto

Setup.

Possible Explanation

A same print server name or queue names exists in the specific NetWare file server as the

one you specified in the Auto Setup dialogue box.

Solution

Specify a new print server name or queue name in the Auto Setup.

Question G

The setup Wizard can’t find print server.

Possible Explanation

The Personal Firewall installed in your computer blocks the connection.

Solution

Please disable the Personal Firewall or adjust the security level to lower.

Hamlet HPS01NW User Manual

Questions and Answers: