Hammond M-SOLO - Updating the Software; Preparing Operating Time; Preparing Update File; Preparing Media

*#1
Owner’s Manual
34
UPDATING THE SOFTWARE
Periodically, software updates o ering enhanced or additional features may be
made available for this instrument.
 is mode allows you to update the software of this instrument from a computer
via USB cable.
PREPARING OPERATING TIME
The update process may take several minutes depend-
ing on the extent of the update. Therefore, if you are
updating the System Software, be sure you set aside
enough time in an environment with a continuous AC
power supply.
PREPARING UPDATE FILE
① DOWNLOAD THE UPDATE
Go to the Hammond website for your region and download
the software update to the desktop of your computer.
www.suzuki-music.co.jp/support/hammond/
It will be a compressed  le containing several  les called a “.zip”
 le.
② UNZIP THE FILE
Find the “.zip”  le on the desktop on your computer and un-
ZIP it. A folder will be created on your desktop having the
same name as the “.zip”  le which will contain the software
update  les, called “.bin”  les.
NOTE: Some web browsers will automatically un-ZIP a “zip”  le after
it has been downloaded.
PREPARING MEDIA
① MAKE THE CONNECTION
Computer
Connect the [TO HOST] port and the computer via USB
“A - B” cable.
Turn on the computer.
② START WITH MASS STORAGE MODE
Turn on this instrument with pressing 3 buttons [TRANS-
POSE], [DOWN] and [UP] until LED on the [SYSTEM]
starts  ashing.
 is instrument starts with the Mass Storage mode and the
computer will recognize this keyboard as a USB external drive
“M-solo.”
OPERATION PROCEDURE
① COPY THE “.BIN” UPDATE FILE(S)
XXXX.bin
YYYY.bin
ZZZZ.bin
M-SOLO
Computer’s
setup
system
COPY
Copy the “.bin” update  les into the “system” folder of this
instrument.
② START THE UPDATE
Press the [SYSTEM] button to start the update.
 e LEDs indicates status below;
Progress
Light
 e [SYSTEM] button LED lit, [MODE] LED runs:
The update process is running. Please wait a minute. The
[TYPE] LEDs will “OFF” by update progress.
Blink
Light
 e [SYSTEM] button LED blinks, [MODE] “V-2” LED lit:
 ere is no update  le. Please try again from step 1 of this
procedure.