18
3.2 Installation Environment Requirements
The robot should be installed indoors and meet the following requirements:
Room temperature of 0-50℃ (to prevent excessive temperature change).
Relative humidity of 10-80% (no condensation).
Avoid direct sunlight.
Keep it away from dust, soot, salt, metal powder and water.
Avoid shock and vibration.
Keep it away from flammable, explosive and corrosive gas-solid liquids.
Keep it away from electrical interference sources.
For the details about the installation space scope of the robot, please refer
to the robot dimension chart and the specification table of electric control box.
3.3 Installation Space
Please confirm the installation space according to the Robot Working Space and the
Size and Specification of Electric Control Box.
Warning：
In addition to the space required for installing the robot and electric
control box, please ensure the minimum space required for the
following conditions: there is enough space to install robot terminal
fixture and workspace, enough space for robot teaching, enough
space for operator to implement installation, inspection and repair
activities, and enough space of gas path.
The minimum bending radius of the robot power cord is 90mm. When
installing the cable, please make sure that there is enough space to
install power supply signal line and other cables, so as to prevent the
cable from over bending.
Please make sure that the safety distance is at least 100mm longer
than the maximum working space of the robot after installing the jig at
the robot terminal.
To Next Page
Loading...