TROUBLE SHOOTING
WARNING:
MAKE SURE THAT THE TRACTOR IS SHUT OFF AND THE MERGER CAN NOT
MOVE BEFORE SERVICING THE TWIN MERGER. MAINTENANCE AND REPAIR
SERVICE WORK TO BE PERFORMED BY A QUALIFIED SERVICE PERSON ONLY.
TROUBLE... POSSIBLE CAUSE... POSSIBLE REMEDY...
Merger Will Not Swing Into Transport Lock Pin Still Remove Transport Lock Pin
Field or Transport Position Engaged
Hydraulic Hoses Not Connected Connect Hoses To Tractor Remote
To Tractor Remotes Outlets
Hydraulic Hoses Mixed Up With Sort Hydraulic Hoses Correctly And
Pickup Lift Hoses Re-Couple To Tractor Remote
Outlets
Merger Pickup Heads Will Hydraulic Hoses Not Connected Connect Hoses To Tractor Remote
Not Raise Or Lower To Tractor Remotes Outlets Outlets
Hydraulic Hoses Mixed Up With Sort Hydraulic Hoses Correctly And
Merger Swing Cylinder Circuit Re-Couple To Tractor Remote
Outlets
Pickup Transport Locks Still Rotate Transport Lock Valves
Engaged
No Power To Control Box Check Tractor 7-Pin Connector For
Power
Control Box Not Plugged Into Plug Control Box Wiring Harness
Merger Main Harness Into Main Harness
Merger Pick Or Cross PTO Shaft Not Connected To Connect PTO Shaft To Tractor
Conveyor Will Not Run Tractor
PTO Not Turning Engage Tractor PTO
Suction Ball Valve Turned Off Turn Ball Valve At The Front Of The
Merger Tongue
System Relief Valve Sticking Contact Your Dealer For Proper
Testing
Cross Conveyor Will Switches On Control Box Move Toggle Switch To Right
Not Run In Neutral Position or Left
Control Box Not Properly Properly Connect Control Box Plugs
Connected To Tractor Or
Wire Harness
-32-
To Next Page
Loading...
