Delivery
15.11.2018
DOUBLE-SEAT VALVE INOVA (Type 580)
BA 058000.06 EN 11 / 36
3 Delivery
3.1 Transport
The double-seat valves or prefabricated valve units should remain in the delivered packing
systems until assembly.
After unpacking the goods and before assembling them the operating manual must be read.
Warning – Danger to persons!
Possibly supplied foil packings are airtight. Therefore never pull packing material over
the head. Otherwise, there is a danger of suffocation!
Warning – Danger to persons!
Lifting equipment or aids that are too weak can break.
Always make sure of sufficient carrying capacity when selecting lifting equipment or
aids.
Only use tested and approved lifting equipment and aids such as:
Shackles e.g. complying with DIN 82101
Slinging chains e.g. complying with DIN 5687 Quality Class 8
3.2 Instructions for Delivery and Performance
• Check the delivery note data for factual correctness.
• Check the delivery for completeness. Later complaints will not be accepted.
• Carry out a visual inspection of the packing system for external transport damages.
These should be brought to the attention of the forwarder immediately. Complaints
for unrecognizable transport damages should be made within a week.
3.3 Storage Instructions
The goods should be stored in dry, closed rooms if possible in the original packaging. UV
radiation and direct sunlight should be avoided. The maximum air moisture should be no
higher than 60%; the maximum storage temperature should not exceed 40%.
3.4 Disposal of Packaging
Note
The packaging should be disposed of in a proper and environmentally friendly way.
National regulations should be adhered to.
To Next Page
Loading...
Need help?
General
