41
Parts Needed
Fuselage
Wing
Decal sheet
Tools and Adhesives Needed
Ruler
Scissors
Soft cloth
Masking tape (optional)
Step 1. Locate the decal sheet included in the kit. Use the box
art photos as an approximate position reference for the applica-
tion of the included decals.
Step 2. Using the box as a reference, cut out the decals for the
cowl Moki
™
, JR
®
as applicable. If you’re using a different engine
or radio, you can apply decals applicable to the equipment you
have. Apply the decals to the cowl and rub with a soft cloth to
work out any bubbles or wrinkles.
Step 3. Next, apply the Hangar 9
™
decal to the wheel pants.
Step 4. The Aeroshell decal can be applied to both sides
of the fuselage turtledeck behind the canopy, as shown in the
photo below.
Step 5. The IMAC and American flag are applied to both sides
of the vertical stabilizer and rudder as shown.
Section 21: Adding Decals
To Next Page
Loading...
