Hangar 9 80" CAP 232 - Other Items Needed (Not Included in the Kit); Tools and Adhesives Needed (Not Included in the Kit); Additional Needed Items; Contents of Kit

5
Other Items Needed (not included in the kit)
Zenoah
®
Gas Start Kit (ZEN20002) Includes:
Tools and Adhesives Needed (not included in the kit)
Additional Needed Items
Horns ROC01B (3)
Pro-links 3" (2) (HAN3553)
Pro-link 4
1
/2" (2) (HAN3550)
Ball Links (ROC87)
Tail Wheel Assembly (SUL861)
Heavy-Duty Servo Arm (4) (HAN3574/HAN3575)
Rudder Cable Set (DUB518)
3/16" Axles
3" Wheels
24 oz Fuel Tank (DUB424)
Fuel Filler (HAN115)
Kill Switch (gas engine) (ZEN2000)
Throttle Linkage
Adhesives
Thick CA (cyanoacrylate) glue
CA remover/debonder
30-minute epoxy
5-minute epoxy
Silicon glue
Canopy glue
Blue Lockite
Electrical tape
Masking tape
Tools
Drill
Drill Bits: 1/16", 1/8", 5/32", 3/8", 5/16"
Medium Phillips screwdriver
Small straight screwdriver
Needle-nose pliers
Hobby knife with #11 blade
Mixing stick
Straight edge
Soldering iron
Measuring device (36") (ruler, tape measure)
Scissors
Moto-tool with cut-off wheel
8-32 Tap (DUB363)
Sealing Iron (HAN135)
Glue syringe or toothpick
Hex Wrench: 5/32" and 1/8"
Adjustable wrench
Countersink
3" Spinner (Tru-turn TRU3002)
Propeller (refer to your engine’s operating instructions)
2' fuel tubing
Coarse sandpaper
Radio packing foam
Antenna tube
8-32 x 1
1
/2" cap screws (4)
1/4 Scale Pilot (HAN8272)
Paper towels
Rubbing alcohol
Felt-tipped pen/pencil
Hangar 9
™
UltraCote
®
(HANU887)
(used for sealing aileron/elevator hinge gap)
Contents of Kit Large Parts
A. Fuselage (HAN2201)
B. Wing Set (HAN2202)
C. Horizontal Stabilizer with/Elevator(s) (HAN2203)
D. Vertical Stabilizer w/Rudder (HAN2204)
E. Canopy (HAN2205)
F. Landing Gear (HAN2206)
G. Wheel Pants (HAN2207)
H. Cowl (HAN2208)
H
A
B
E
F
G
C
D