26
Press the RANGE key. The day will start blinking.
Press the ARROW keys to change the day.
Press the CFM key to save the modified value or press the CAL key to
escape without saving.
BEEP STATUSBEEP STATUS
BEEP STATUSBEEP STATUS
BEEP STATUS
Press CAL when the beep status is displayed. Beep status (“On” or
“OFF”) will start blinking.
Press the ARROW
keys to change the beep status (On or OFF).
Press CFM to save the modified beep status.
Press CAL to escape without saving.
When enable, beep sounds as a short beep every time a key is pressed or
when the calibration can be confirmed.
A long beep alert that the pressed key is not active or a wrong condition
is detected while in calibration.
II
II
I
NSTRUMENT IDNSTRUMENT ID
NSTRUMENT IDNSTRUMENT ID
NSTRUMENT ID
Press the CAL key when “InId” is displayed. The instrument ID (“0000”
to “9999”) will begin blinking.
Press the ARROW
keys to change the instrument ID value.
Press the CFM key to save the modified instrument ID value or press the
CAL key to cancel without saving the instrument ID.
Note: The instrument ID is downloaded to a PC as part of a logged data
set to identify it’s origin.
TEMPERATURE UNITTEMPERATURE UNIT
TEMPERATURE UNITTEMPERATURE UNIT
TEMPERATURE UNIT
Press CAL when “tenP” is displayed. The temperature unit will start
blinking.
Press the ARROW keys to change the option.
Press CFM to save the modified temperature unit.
Press CAL to escape without saving.
To Next Page
Loading...
Need help?
General
