5554
This feature allows the user to log pH, Rel mV, ISE, EC, TDS, NaCl or
Resistivity measurements. All logged data can be transferred to a PC
through the USB port.
The logging space includes 400 records of Log on demand and 600
records of Log interval (lot logging). The log interval is organized in lots.
A maximum of 100 lots are accepted. One lot can occupy all the memory
space available.
LOGGING THE CURRENT DATA
To store the current reading into memory, press Log while in measurement
mode.
The instrument will display for few seconds the record number and the
amount of the free log space.
If the LOG space is full, the “Log space is full” message will be displayed
for few seconds when Log key is pressed. Enter View Logged Data Mode
and delete records in order to free log space.
LOT LOGGING
Select the desired interval in SETUP as a timed interval or AutoEnd waits
for a stable value before logging.
Press the StartLog function key in order to start Log interval.
Press the StopLog function key in order to stop logging and close current lot.
LOGGING
Use ARROW keys to change the cell constant value.
Press Accept to confirm or ESC to exit without changing.
Note: If the cell constant value is modified, the EC slope calibration is
deleted and the NaCl calibration is deleted. If performed, the EC
offset calibration remains active.
Temperature Coefficient
Focus on the
Temperature Coef.
item.
Press Modify in order to set the temperature coefficient.
Use the ARROW keys to change the value.
Press Accept to confirm or ESC to exit without changing.
Temperature Reference
Focus on the
Temperature Ref.
item.
Press the corresponding functional key to select the desired reference
temperature.
To Next Page
Loading...
Need help?
General
