6766
encoding
• 0x01 - beep ON (else OFF)
• 0x02 - degrees Celsius (else Fahrenheit)
• 0x04 and 0x08 - this 2 bits represent the
temperature compensation mode (10 - ATC,
01 - MTC, 00 - NoTC)
• The cell constant, with sign and decimal point (7 chars)
• The temperature compensation coefficient, with sign
and decimal point (6 chars)
• The temperature reference value (2 chars)
• The TDS factor, with sign and decimal point (5 chars)
• The short name of the selected language (3 chars)
NSLxy Requests the number of logged samples (4 chars).
The command parameter (2 chars):
• x=1 request for channel 1
• x=2 request for channel 2
• y=P request for pH range
• y=M request for mV and Rel mV ranges
• y=I request for ISE range
• y=E request for EC range
• y=R request for Resistivity range
• y=T request for TDS ranges
• y=N request for NaCl range
LLSxy Requests the number of lots (information about lots) on the specified
channel and range (x - channelnumber; y - range first letter)
• x=1 request for channel 1
• x=2 request for channel 2
• y=P request for pH range
• y=M request for mV and Rel mV ranges
• y=I request for ISE range
• y=E request for EC range
• y=R request for Resistivity range
• y=T request for TDS ranges
• y=N request for NaCl range
The answer string contains:
• number of lots (3 chars)
For each lot:
• the lot number (3 chars)
• the number of records in lot (3 chars)
sign and decimal point (6 chars)
• Salinity calibration data (if available), which contains:
• the number of calibrated standards (1 char always 1)
• the salinity factor, with sign and decimal point
(7 chars)
• calibration time, yymmddhhmmss (12 chars)
PARx Requests the setup parameters setting.
• x=1 setup parameters for channel 1
• x=2 setup parameters for channel 2
The answer string contains:
• Lot log interval index (2 ASII chars - it represents
the index from the setup list for the log interval)
• Backlight Value (1 ASCII char)
• Contrast Value (2 ASCII char)
• Instrument ID (4 chars)
Channel 1 data
• Calibration Alarm time out for pH (2 chars)
• Calibration Alarm timeout for ISE (2 chars)
• SETUP information (2 chars): 8 bit hexadecimal
encoding.
• 0x01 - beep ON (else OFF)
• 0x02 - degrees Celsius (else degrees Fahrenheit)
• 0x04 - Offset calibration (else Point calibration)
• The number of pH custom buffers (1 char)
• The custom buffer values, with sign and decimal
point, for each defined custom buffer (7 chars)
• The ID of the ISE electrode (2 chars) (standard or
custom)
• The molar weight of the selected ION, with sign and
decimal point (9 ASCII characters)
• The electrode slope (6 ASCII chars)
• The ion charge (2 chars)
• The ISE unit (2 chars)
• The short name of the selected language (3 chars)
Channel 2 data
• Calibration alarm timeout for the EC (2 chars)
• Calibration alarm timeout for the Salinity (2 chars)
• Setup information (2 chars): 8 bit hexadecimal
To Next Page
Loading...
Need help?
General
