15
OPERATIONAL GUIDE
POWER CONNECTION
Connect the AC/DC adaptor that is supplied with the instrument.
Note: Always turn the meter off before unplugging it to ensure no data is lost.
METHOD SELECTION
• Turn the instrument ON via the ON/OFF power switch.
• The meter will perform an autodiagnostic test. During this test, the Hanna Instrument logo will appear
on the LCD. After 5 seconds, if the test was successful, the last method used will appear on the display.
• In order to select the desired method press the METHOD key and the screen with the list of methods
will appear.
• Press the s t keys to highlight the desired method. Press Select.
• After the desired method is selected, follow the measurement procedure described in the related chapter.
• Before performing a test carefully read all the instructions related to the selected method.
To Next Page
Loading...
Need help?
General
