21
Chapter 3 - SETUP MODE
A few parameters have to be set before taking any measurements. In the main
menu two setup options are available: “Measurement” and “System”.
Measurement setup allows to set the displayed readings and their units, while
the system setup is used to set all system parameters, as the interface language,
date and time, LCD contrast, acoustic signals, etc.
3.1 MEASUREMENT SETUP
• Switch the meter on by pressing on/off.
After the initialization has been completed, the
meter enters the measurement mode. The active
softkeys are <Log> and <Menu>.
• Press <Menu>, select “Measurement Setup” us-
ing the arrow keys, then press <OK>.
• The display shows the complete list of measur-
able parameters.
• To select a parameter, scroll with the arrow keys.
Each parameter can be enabled or disabled. A checked box or the measure unit
means that the parameter is enabled. Press the right softkey to enable or disable
the parameter.
Some parameters also allow to select measure unit and resolution by pressing
the <Unit> or <Resolution> softkey respectively.
NoteNote
NoteNote
Note If the password protection is enabled, the meter will ask to insert the
password prior to change the first parameter.
Temperature
The user can select the measure unit: °C, °F or K.
To Next Page
Loading...
Need help?
General
