Need help?Do you have a question about the Hanna Instruments HI 9829 and is the answer not in the manual?
General| Measurement Parameters | pH, ORP, Temperature, Dissolved Oxygen, Conductivity, TDS, Salinity |
|---|---|
| pH Range | -2.00 to 16.00 pH |
| pH Resolution | 0.01 pH |
| pH Accuracy | ±0.02 pH |
| ORP Resolution | 1 mV |
| ORP Accuracy | ±1 mV |
| Temperature Resolution | 0.1 °C |
| Dissolved Oxygen Resolution | 0.01 mg/L |
| Salinity Resolution | 0.01 PSU |
| IP Rating | IP67 |
| Type | Multiparameter Meter |
| ORP Range | -2000 to 2000 mV |
| Temperature Accuracy | ±0.5 °C |
| Dissolved Oxygen Range | 0 to 20 mg/L |
| Dissolved Oxygen Accuracy | ±1.5% of reading |
| Conductivity Resolution | 0.001 mS/cm |
| Conductivity Accuracy | ±1% of reading |
| TDS Accuracy | ±1% of reading |
| Salinity Range | 0 to 70 ppt |
| Salinity Accuracy | ±1% FS |
| Battery Type | 4 AA batteries |
| Display | LCD with Backlight |
| Dimensions | 185 x 93 x 37 mm |
| Weight | 400 g (with batteries) |
Step-by-step guide for connecting sensors and probes to the HI 9829 meter.
Technical specifications for the meter, including ranges for temperature, pH, ORP, DO, and EC.
Procedures for preparing and activating specific sensors before use.
Instructions on how to physically install sensors into the HI 9829 probe.
How to enable or disable specific measurement parameters on the meter.
Configuration of measurement units for various parameters like temperature, TDS, and pressure.
Performing single-point calibrations for pH, conductivity, and dissolved oxygen.
Detailed procedure for calibrating the pH sensor using buffer solutions.
Steps for calibrating Ion Selective Electrodes (ISE) using standard solutions.
Performing single-point custom calibration for ORP measurements.
Calibrating dissolved oxygen measurements in % saturation or concentration.
Calibrating conductivity, absolute conductivity, and salinity measurements.
Performing multi-point calibration for turbidity sensor accuracy.
Configuring meter settings like time, date, auto power-off, and key beeps.
Setting up probe identification and password protection.
Steps for connecting the meter to a PC for data transfer.
Steps for connecting a logging probe to a PC for data transfer.
Explains common error messages and their potential causes and solutions.
To Next Page
