52
Chapter 8 - SYSTEM SETUP
From the main menu, select “System setup” and
then “Meter setup” or “Probe setup”.
8.1 METER SETUP
Note If the password protection is enabled,
you will be required to enter the pass-
word before any settings can be modi-
fied.
8.1.1 Time
The meter uses a real time clock for logging. The
time and time format are set in this function.
Press <Modify> and set the time using the key-
pad. Press <Accept> to save the time. When us-
ing the 12 hour format, press A or P on the key-
pad for AM or PM after you set the time.
Press <Format> to change between 12 and 24
hour formats. The default format is 24 hours.
8.1.2 Date
The date and date format are set in this function.
Press <Modify> and set the date using the key-
pad. Press <Accept> to save the date.
Press <Format> to change between the avail-
able date formats: DD/MM/YYYY, MM/DD/YYYY,
YYYY/MM/DD, YYYY-MM-DD, MM-DD-YYYY,
and DD-MM-YYYY. The default format
is YYYY/MM/DD.
To Next Page
Loading...
