21
METHOD PROCEDURE
8. METHOD PROCEDURE
8.1. FREE CHLORINE (POWDER REAGENT)
Note: Free and Total Chlorine have to be measured separately with fresh unreacted
samples, following the related procedures, if both values are desired.
REQUIRED REAGENTS
Code Description Quantity
HI93701-0 Free Chlorine Reagent 1 packet
REAGENT SETS
HI93701-01 Free Chlorine Reagent - 100 tests
HI93701-03 Free Chlorine Reagent - 300 tests
For other accessories see ACCESSORIES section.
MEASUREMENT PROCEDURE
• Select the Free Chlorine (Powder) method using the procedure described in the
METHOD SELECTION section.
Note: If tutorial mode is disabled, follow the measurement procedure below. If the
tutorial mode is enabled, press Measure and follow the messages on the screen.
• Fill the cuvette with 10 mL of unreacted sample (up
to the mark). Replace the plastic stopper and the cap.
• Insert the cuvette into the holder and ensure that the
notch on the cap is positioned securely in the groove.
• Press Zero. The display will show “-0.0-” when the meter is zeroed and ready for
measurement.
10 mL
To Next Page
Loading...
