27
It takes about 6 hours to completely charge fully discharged
batteries.
Note: The meter log, GPS information, system setup
and status can be viewed during battery charging. The
battery charging status is indicated by a small animated
battery icon found in the lower left corner. During charging the meter may feel quite warm. This
is normal. “Battery temp” (under “Meter Status”) may display values approaching 50 °C.
Automotive auxiliary power outlet (Cigarette lighter receptacle)
To charge batteries from an automotive auxiliary power outlet, use HI710046 cable.
• Connect the HI710046 cable to the probe connector on the meter and to the auxiliary plug.
• The battery charging animation will be displayed.
A complete battery charging will take about 6 hours if they are completely discharged.
Probe Battery Installation (for logging probes only)
To install probe batteries:
Replace batteries in a safe area only. Remove the battery cover by turning it counterclockwise. Insert
the batteries observing polarity.
Note: Do not mix old and new batteries.
Replace the battery cover by engaging the threads and turning it clockwise. Continue turning until it
is flush with probe body.
BATTERY INSTALLATION
To Next Page
Loading...
