28
After connecting the desired sensors to the probe and connecting the probe to the meter (see previous
chapter), turn the meter on by pressing ON/OFF.
After the initialization has been completed, the meter displays the PROBE STATUS SCREEN.
The probe status screen identifies the probe and attached sensors. Non‑logging probes are identified
as HI7609829 and logging probes are identified as HI7629829.
Two active soft keys are found at the bottom of the status screen.
• Press <Measure> to access the measurement mode.
•
P
ress <P
aram.> to access the “Select P
arameter
” menu. (This screen can also be accessed from
the main menu, see Chapter 6 for a detailed description.).
• Press the key to view additional information about the probe.
METER INITIALIZATION
To Next Page
Loading...
