53
Auto Poweroff
The Auto Poweroff function is used to save battery life. After
the set time is elapsed, the meter will:
1. automatically switch off, if in normal measurement mode.
Press On/Off to switch on again.
2. enter a sleeping mode, if the continuous logging mode
is selected with a logging interval of at least 30 seconds. The “Auto Poweroff” message and the
<Wake up> softkey appear on the LCD; logging is not stopped. Press <Wake up> to reactivate
the display.
Available options are: Not used (disabled), 5, 10, 15, 20, 30 or 60 minutes. Press <Modify> to
select the desired time interval. The default value is “not used”.
Key Beep
If enabled, an acoustic signal sounds every time a key is
pressed. A checked box indicates this function has been
enabled. The default setting is disabled.
Error Beep
If enabled, an acoustic signal sounds every time an incorrect
key is pressed, or when an error occurs. A checked box indicates
this function has been enabled. The default setting is disabled.
Decimal Separator
The user can select the type of decimal separator: “dot” or
“comma”. Press the softkey to select the desired option. The
default setting is “dot”.
LCD Contrast
The LCD contrast can be adjusted with this function. Press
<Modify> to enter this function.
Use the / keys to change the contrast level and press
<Accept> to save the new value. The default value is 8.
METER SETUP
To Next Page
Loading...
