55
Restore factory settings
This function restores measurement settings to their original
factory values. This includes measurement units, coefficients,
other measurement configurations and all logged data. The
factory calibration for the sensor channels is not affected.
• Select the “Restore factory settings” and press <Select>.
• The meter will ask to confirm: press <Yes> to confirm or <No> to escape.
Probe ID
The probe can be labeled with an identification code: press
<Modify> and a text box will be displayed. Use the
keypad to enter the desired alphanumeric code and then
press <Accept>.
A maximum of 14 characters can be used.
Probe Password
The Probe Password protects the probe against unauthorized configuration changes and log data
erasure. When implemented, many setting and functions cannot be modified or viewed.
To enable the password:
• Highlight the “Probe Password” and press <Modify>.
• Enter the desired password in the text box and press <Accept>.
Note: While typing, the characters are masked with “*” (star) symbols.
• The probe will require confirmation. Retype the same password and press <Accept> to confirm.
• The meter returns to the “Probe Setup” menu. The checkbox corresponding to the probe password
is checked.
To disable the password, highlight the “Probe Password” and press <Modify>. Enter the password
and then press <Disable>. “No password” appears in the text box. Press <Accept> to confirm.
PROBE SETUP
To Next Page
Loading...
