EasyManuals Logo

Hanseatic HTW7512C User Manual

Hanseatic HTW7512C
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
Page EN-8 Safety
NOTICE
Risk of damage to property!
Improper transport and installation
may result in damage to the appliance.
If a trolley is used to move the ap-
pliance, the appliance must be lifted
as shown on the packaging. Always
transport the appliance vertically.
Do not use any sharp or pointed ob-
jects when unpacking the appliance.
Do not pull on the appliance lid.
Remove all packaging material be-
fore fi rst use.
Make sure the appliance is not con-
nected to the power supply whilst the
transport safety devices are being re-
moved or installed.
For rugs, carpet, parquet or wooden
oorboards, place a stable wooden
plate measuring at least 40 × 60 cm
underneath the appliance.
Do not stand the appliance on rugs or
carpets. Otherwise, it may not be able
to properly ventilate, which can result
in overheating and damage to it.
When positioning on a wooden plate
or base, these must be equipped with
indentations for the screw-on feet so
that the appliance does not migrate
off it when spinning.
Do not place the appliance on top of
other appliances and do not use it as
a base for other appliances (e.g. for
dryers).
Do not sit or stand on the appliance.
Improper handling of the appliance
can lead to water damage.
Do not leave the appliance unsuper-
vised for long periods of time while
the valve is open. When draining
as a result of leakiness, substantial
amounts of water may leak out.
Only connect the appliance to the
cold water supply.
Only connect the appliance to a wa-
ter supply with an inlet water pressure
between 0.1Mpa and 1.0Mpa (1.0 to
10.0bar). For higher water pressure,
a pressure regulator needs to be in-
stalled. Enquire about the water pres-
sure with the local waterworks.
Close the water inlet tap after every
use.
Close the water inlet tap before clean-
ing the water inlet fi lter.
Only use the hose set delivered with
the appliance to connect to the water
supply. Do not use old hose sets.
Do not extend the water outlet hose
or replace it with another hose.
Make sure that the water outlet hose
is not kinked or twisted.
Be aware that substantial amounts
of water may leak out during emer-
gency draining.
Ensure that the water drain is not
above the maximum height (see “In-
tended use”).
Ensure that the water outlet hose is
in the retaining clips on the back of
the appliance so that the curvature
always remains above the waterline.
Do not submerge the end of the hose
in the pumped out water.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hanseatic HTW7512C and is the answer not in the manual?

Hanseatic HTW7512C Specifications

General IconGeneral
BrandHanseatic
ModelHTW7512C
CategoryWasher
LanguageEnglish

Related product manuals