33
-3-
SCOPE
This service manual contains the installation, operating, lubrication and maintenance
instructions relative to the Hansen P4 standardized gear units.
Additional information can be obtained by contacting one of the HANSEN sales centres
worldwide (page 24).
All handling, storage, installation, start-up, inspection and maintenance of
the equipment shall be done by personnel qualified in matters of industrial
mechanical and - where applicable - electrical equipment.
1. GENERAL
1.1. GENERAL INSTRUCTIONS
Carefully read this manual before installing the gear unit.
Compliance with the instructions will assure long and troublefree operation of the gear unit.
The equipment should be checked against shipping papers and inspected for apparent damage
sustained during transport. Any shortage, discrepancy or damage must immediately be reported
to HANSEN.
1.1.1. Warranty
The warranty clause of the "General Conditions of Sale" applies to gear units installed and
maintained as per instructions contained in this manual and in any additional instruction leaflets
supplied with the gear unit insofar as the gear unit operates within the service and rating
conditions put forward in the "Order Acknowledgement" and on the certified drawings.
Non compliance with these instructions, injudicious choice of lubricant or a lack of maintenance
will render warranty agreement invalid.
This warranty clause applies to all parts of the gear unit with the exception of these parts which
are subject to wear.
1.1.2. Safety
It is not allowed to use the gear unit for other applications or in other
operating conditions than the one for which it is ordered.
The user shall be responsible for the proper installation of the complete
equipment and the supply of protection guards and other safety equipment in
accordance with local safety regulations.
Heaters, coolers, electrical alarms and other safety or monitoring devices supplied by HANSEN
with the equipment must be installed and connected by the user as indicated on the relative
document.
1.2. GENERAL SPECIFICATIONS
For general specifications such as dimensions, weight, connecting diagrams, refer to certified
drawing of the gear unit and/or to the Hansen P4 standardized gear unit catalogues.
To Next Page
Loading...
Need help?
General
