Need help?Do you have a question about the Hantek DSO4102 and is the answer not in the manual?
General| Bandwidth | 100 MHz |
|---|---|
| Sample Rate | 1 GSa/s |
| Channels | 2 |
| Display Resolution | 800 x 480 pixels |
| Interface | USB host, USB device |
| FFT | Yes |
| Math Functions | +, -, *, /, FFT |
| Display | 7 inch TFT LCD |
| Input Voltage Range | 400 V (DC + AC peak) |
| Record Length | 40K |
| Vertical Resolution | 8 bit |
| Vertical Sensitivity | 2 mV/div to 10 V/div |
| Timebase Range | 5 ns/div - 50 s/div |
| Trigger Modes | Edge, Pulse, Video, Alternate |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Time Base | 5 ns/div - 50 s/div |
| Input Impedance | 1MΩ ± 2% |
Read safety precautions to avoid injury and prevent damage to the product.
Covers Autoset, saving, and recalling oscilloscope configurations.
Introduces trigger concepts and controls for stable waveform acquisition.
Covers scale and cursor measurements for signal analysis.
Steps to resolve common issues like no power, no waveform display, distorted signals, or trigger problems.
Specifications for trigger sensitivity, level range, modes, and types.
To Next Page
