Need help?Do you have a question about the Hantek Hantek2C42 and is the answer not in the manual?
General| Bandwidth | 40 MHz |
|---|---|
| Channels | 2 |
| Connectivity | USB |
| Vertical Resolution | 8 Bits |
| Multimeter | No |
| Waveform Generator | No |
| Trigger Modes | Auto, Normal, Single |
| Input Coupling | DC, AC, GND |
| Sample Rate | 250 MS/s |
| Vertical Sensitivity | 10 V/div |
| Timebase Range | 5 ns/div |
| Power Supply | 5V DC |
| Input Impedance | 1 MΩ |
Procedure for performing a quick operational test of the oscilloscope.
Guidance on checking and compensating the oscilloscope probes for accurate measurements.
How to use the auto-set feature for quick and stable waveform display.
Process for resetting the oscilloscope to its factory default configuration.
Guide to setting up trigger conditions for capturing specific events.
Methods for measuring signal parameters using graticules, cursors, and auto-measure.
Visual measurement using graticule divisions and scale factor.
Using on-screen cursors for precise time and voltage measurements.
Routine to optimize signal path accuracy and performance.
Detailed steps for measuring voltage, current, resistance, and other parameters.
How to set waveform type, frequency, amplitude, and other parameters.
To Next Page
