HANYOUNG NUX ML-D Series - Page 53

51
Before staring
InstallationInstallation
Operation Specifications
▶ Event output (ML-E)
Event output
(ML-E)
8 points
RELAY
Contact point method: 1a contact point
250 V a.c. 3 A, 30 V d.c. 3 A
Event
type
ML-D2H ML-D4
0 : None(OFF)
1 : Deviation high limit
2 : Deviation low limit
3 : Deviation high/low limit
4 : Within deviation scope
5 : Deviation high limit (stand by)
6 : Deviation low limit (stand by)
7. Deviation low/high limit (stand by)
8 : Within deviation (stand by)
9 : PV high limit
10 : PV low limit
11 : PV high limit (stand by)
12 : PV low limit (stand by)
13 : SV high limit
14 : SV low limit
15 : Loop break alarm (LBA)
16 : Heater break alarm (HBA)
17 : Run start (RUN)
18 : Run/monitor mode (READY)
19 : FAIL
0 : None(OFF)
1 : Deviation high limit
2 : Deviation low limit
3 : Deviation high/low limit
4 : Within deviation scope
5 : Deviation high limit (stand by)
6 : Deviation low limit (stand by)
7. Deviation low/high limit (stand by)
8 : Within deviation (stand by)
9 : PV high limit
10 : PV low limit
11 : PV high limit (stand by)
12 : PV low limit (stand by)
13 : SV high limit
14 : SV low limit
15 : Loop break alarm (LBA)
16 : -
17 : Run start (RUN)
18 : Run/monitor mode (READY)
19 : FAIL
▶ Display
Display score 7점
Display detail
LED display based on status
Power source (PWR): red turns on
Event state (EV): red turns on
RS485 communication state (COM): green turns on
Control state by channel (CH1 ~ CH4): red turns on