Hardi COMMANDER Plus Series

To Next Page

To Previous Page

39HARDI

COMMANDER OPERATOR’S MANUAL

Operating hours

Type of lubricant

Lubrication schedule

Position on the sprayer

Boom

Trailer

Maintenance

B - 50h

2 3

Main Page

Default Chapter4
- Table of Contents4
Introduction6
- COMMANDER Plus7
Description8
- Frame8
- Tank8
- Pump8
- MANIFOLD System8
- Operating Unit8
- Filters8
- Paralift8
- Booms8
- Boom Hydraulics8
Sprayer Use9
Unloading the Sprayer from the Truck9
Before Putting the Sprayer into Operation9
Safety Instructions10
- Operating the Sprayer Safely10
- Handling Chemical Products Safely11
- Local Poison Information Center11
Connecting the Sprayer12
- Drawbars12
- Mounting the Drawbar Hitch12
- Drawbar Hitch Height Adjustment12
- Support Jack12
- Fixed Drawbar Adjustment13
- Steering Drawbar (Optional)13
- Hose Package Support13
Shaft14
- P.T.O. Shaft Operator Safety14
- Installation of P.T.O. Shaft14
Wheel Tread Adjustments15
- Altering the Wheel Track Width15
Axle Systems & Tire Assemblies16
Hydraulic System17
- Hydraulics - Standard Joystick Handle17
- Direct Acting Hydraulic System (D.H.)18
- Control Boxes and Power Supply18
Transport19
- Roadworthiness19
- Rear Lights19
- Transport Brackets, Height Setting19
- Transport Lock19
- Transport Lock Arm Stop20
- Adjusting Boom Transport Position20
Driving Technique21
- Steering Drawbar (Optional)21
Disconnecting the Sprayer22
- Support Leg22
- P.T.O. Shaft Support22
Operating the Boom23
- Unfolding and Folding the HZ EAGLE™ Boom23
- Unfolding and Folding the HZ FORCE™ Boom24
- Tilting the HZ FORCE™ Boom25
ECP Plumbing Diagram26
Operating the Liquid System27
- Manifold System27
- Use of MANIFOLD Valve System27
- Electrical Operated MANIFOLD Valves (Opt.)28
Filling the Tanks on the COMMANDER Plus28
- Filling Main Tank through Tank Lid28
- Filling Flush Tank (Optional) through Lid28
- Filling with External Quick Fill (Optional)29
- Filling of Clean Water Tank29
Adjustment of ECP Operating Unit30
- Adjustment of Constant Pressure30
- Operating the Control Unit While Spraying30
Remote 4” Pressure Gauge31
- Remote 4" Pressure Gauge31
Self Cleaning Filters31
- Choice of Correct Restrictor for S.C.F31
Adjustment of Air Pressure in Pressure Damper (1302 Pump Only)31
Filling of Chemicals32
- Filling through Tank Lid32
- Filling with HARDI32
- Operating with Liquid-Based Chemicals32
- Chemical Filler32
- Operating with Powder-Base Chemicals33
Use of Flush Tank and Rinse Nozzles (Optional)34
Technical Residue34
Draining Tanks34
- Main Tank Drain Valve34
- Flush Tank (Optional)34
- Foam Marker Tank (Optional)34
Nozzle Selection35
Calibration37
Maintenance - Rules of Thumb38
- Cleaning the Sprayer38
- Cleaning the Tank39
- Cleaning and Maintenance of Filters39
Lubrication40
- About Lubricants40
- Recommended Lubricants40
- Lubrication Schedule41
Service and Maintenance Intervals44
- Hours Service44
- 1000 Hours Service or Yearly44
- Occasional Maintenance45
Off-Season Storage52
- Preparation after off Season Storage52
Equipment and Accessories53
Troubleshooting57
Emergency Operation of the Sprayer62
Technical Specifications63
- Overall Measurements63
- Weight63
- Filters and Nozzles64
- Temperature and Pressure Ranges64
- Electrical Connections Rear Lights64
- Electrical Connections for ECP Operating Unit64
Installation Instruction for Boom and Work Light65
EAGLE™ and FORCE™ Boom Hydraulics66
Warranty Policy and Conditions67

Table of Contents

Related product manuals