SYSTEM UPDATE
EXIT/CONTINUE
Press the OK button to continue. The front panel display will show
Searching as the system looks for the correct file on the USB drive.
When the file with the update information is located, the display will read
SYSTEM UPDATE
EXIT/CONTINUE
Press the OK button on the remote, and the following will happen
automatically:
o The front panel display will go dark.
o The volume indicator will also go dark and will then blink to indicate
that the new software is being installed.
o After a few minutes, the AVR will briefly go into the Standby mode
as indicated by the Power indicator turning from white to amber.
o The unit will turn back on, indicating that the software has been
installed.
Once the unit turns on, check to make certain that the new software has
been installed by following these steps:
o Press the DVD source button and then press the AVR button.
o Press 1-2-3-4-OK on the remote control to display the version
number and check to make sure it matches the information shown
below to make certain that your unit is now loaded with the proper
software. If a different number appears, please repeat the upgrade
process.
V1.1 M
17-03-2009 02 U
After a brief pause, the display will show the following information:
DSP VERSION
1.1.1
o You may wish to write this upgrade information in your owner’s
manual so that you’ll have it available for reference. When new
software is made available through www.harmankardon.com, it will
show the number of the latest version. You will need this
information to see if an additional upgrade is required.
Your new software is now installed. Before your first listening session, all that
remains is to re-enter any input and speaker configuration information and any
tuner presets you wish to use. For optimal performance, we also recommend that
To Next Page
Loading...
