62 APPENDIX
APPENDIX
System Defaults
The two tables in this section show the factory default settings for the Video Inputs, Video Sources and Video Display Aspect Ratios. These tables give you the
complete picture on the AVR 445’s initial settings. You may then decide whether any item needs to be changed so that it is more appropriate for your specific
installation. Any of the settings shown may be changed as shown in the pages of the System Configuration section of this manual (pages 23 to 35).
Table 1: Video Input Defaults
INPUT AUDIO VIDEO COMPONENT RECORD
INPUT INPUT VIDEO INPUT OUTPUT
Video 1 ANALOG AUTO OFF ANALOG
Video 2 ANALOG AUTO OFF ANALOG
Video 3 OPTICAL 1 AUTO COMPONENT 1 ANALOG
Video 4 ANALOG AUTO COMPONENT 2 ANALOG
DVD COAX 1 AUTO COMPONENT 3 ANALOG
HDMI 1 OPTICAL 3 HDMI 1 --- DSP DOWNMIX
HDMI 2 COAXIAL 3 HDMI 2 --- DSP DOWNMIX
Tuner ANALOG AUTO OFF ANALOG
CD ANALOG AUTO OFF ANALOG
Tape ANALOG AUTO OFF ANALOG
DMP/The Bridge ANALOG AUTO OFF ANALOG
6/8 CH Direct ANALOG AUTO OFF ANALOG
USB --- AUTO OFF DSP DOWNMIX
System Default and Personal Settings Worksheets
The worksheets in this section show the system defaults for the global settings on your AVR 445. Once your system is configured manually, or through the
use of EzSet/EQ, where applicable, we recommend that you use the “Your System Settings” column to record your personal preferences so that they may be
restored in the event the AVR’s memory is lost due to an extended power outage, system upgrade, processor reset, or other major service to your unit.
Additional copies of this worksheet may be downloaded from the Harman Kardon web site at www.harmankardon.com
To Next Page
Loading...
Need help?
General
