Harman Kardon AVR247 User Manual

SAFETY PRECAUTIONS
The following check should be performed for the continued
protection of the customer and service technician.
LEAKAGE CURRENT CHECK
Measure leakage current to a known earth ground (water
pipe, conduit, etc.) by connecting a leakage current tester
between the earth ground and all exposed metal parts of the
appliance (input/output terminals, screwheads, metal
overlays, control shaft, etc.). Plug the AC line cord of the
appliance directly into a 120V AC 60Hz outlet and turn the
AC power switch on. Any current measured must not exceed
o.5mA.
ANY MEASUREMENTS NOT WITHIN THE LIMITS
OUTLINED ABOVE ARE INDICATIVE OF A
POTENTIAL SHOCK HAZARD AND MUST BE
CORRECTED BEFORE RETURNING THE APPLIANCE
TO THE CUSTOMER.
Device
under
test
Test all
exposed metal
surfaces
Also test with
plug reversed
(Using AC adapter
plug as required)
AC Leakage Test
Leakage
current
tester
Reading should
not be above
0.5mA
Earth
ground
3
AVR247 harman/kardon

Harman Kardon AVR247 Specifications

General

Number of Channels	7.1
HDMI Inputs	2
HDMI Outputs	1
Dolby Digital	Yes
DTS	Yes
Type	AV Receiver
Input Sensitivity	200 mV
Signal to Noise Ratio	100 dB
Total Harmonic Distortion	0.07%
Component Video Inputs	3
Component Video Outputs	1
Power Output	50 Watts per channel
Surround Sound Formats	Dolby Digital, DTS, Dolby Pro Logic II
Video Inputs	Composite, S-Video
Video Outputs	Composite, S-Video
Dimensions	440 x 165 x 382 mm
Frequency Response	10 Hz - 100 kHz
Audio Inputs	Analog, Optical, Coaxial