Harman Kardon AVR45 User Manual

Rear Panel Connections
10
ª Subwoofer Pre-Out: Connect
this jack to the line level input of a
powered subwoofer. If an external
subwoofer amplifier is used, connect
this jack to the subwoofer amplifier
input.
‚ Front: Connect these terminals to
the front left/right speakers.
⁄ Center: Connect these terminals
to the center speaker.
l Surround: Connect these terminals
to the surround speakers.
‹ Unswitched AC Outlet: This
outlet may be used to power any AC
device. The power will remain on at
this outlet regardless of whether the
AVR45 is on or off.
NOTE: The power consumption of
the device plugged into each of
these outlets should not exceed
100 watts.
› Switched AC Outlet: This outlet
may be used to power any device
that you wish to have turn on when
the unit is turned on with the System
Power Control switch 2.
fi Power Cable: Connect the AC
plug to a non-switched AC wall
output
fl Video 2 Inputs: Connect these
jacks to the audio and video outputs
of a TV Tuner, Cable TV converter
box, satellite receiver or any other
audio/video source.
‡ TV Monitor Video Output:
Connect this jack to the standard
(composite) video input of a TV
monitor or video projector to view
the on-screen menus and the
output of any standard video source
selected by the receiver’s video
switcher.
° AC-3/PCM Coaxial Input:
Connect the coax digital output from
a DVD player, HDTV receiver, LV
player or CD player to this jack. The
signal may be either a Dolby Digital
(AC-3) signal or a standard PCM
digital source.
· AC-3/PCM Optical Input:
Connect the optical digital output
from a DVD player, HDTV receiver,
LV player or CD player to this jack.
The signal may be either a Dolby
Digital (AC-3) signal or a standard
PCM digital source.
a Remote IR In: If the AVR45’s front
panel IR sensor is blocked due to
cabinet doors or other obstructions,
an external IR sensor may be used.
Connect the output of the sensor to
this jack.
b Remote IR Out: This connection
permits the IR sensor in the receiver
to serve other remote controlled
devices. Connect this jack to the “IR
IN” jack on Harman Kardon or other
compatible equipment.
c Tape Monitor In: Connect these
jacks to the PLAY/OUT jacks of an
audio recorder.
d Tape Monitor Out: Connect these
jacks to the RECORD/INPUT jacks of
an audio recorder.
AVR45 om (G).Eng,Fr 4/16/99 11:41 AM Page 10

Harman Kardon AVR45 Specifications

General

Brand	Harman Kardon
Model	AVR45
Category	Receiver
Language	English