¡ AM Antenna
™ FM Antenna
£ Phono Ground
¢ Remote IR In
∞ Remote IR Out
§ Phono Inputs
¶ CD Inputs
• Aux Inputs
ª Tape Monitor Play/In
‚ Tape Monitor Record/Out
⁄ Tape 2 Play/In
Tape 2 Record/Out
‹ Main In
› Preamp Out
fi Subwoofer Out
fl Speaker 1 Terminals
‡ Speaker 2 Terminals
° Accessory Outlets
· Power Cable
¡ AM Antenna: Connect the AM
loop antenna supplied with the
receiver to these terminals. If an
external AM antenna is used, make
connections to the AM and GND
terminals in accordance with the
instructions supplied with the
antenna.
™ FM Antenna: Connect an indoor
or external FM antenna to this
terminal.
£ Phono Ground: Connect the
ground wire from a turntable to this
terminal to reduce system hum.
¢ Remote IR In: If the HK3270’s
front panel IR sensor is blocked due
to cabinet doors or other obstructions,
an external IR sensor may be used.
Connect the output of the sensor to
this jack.
∞ Remote IR Out: This connection
permits the IR sensor in the receiver
to serve other remote controlled
devices. Connect this jack to the
“IR IN” jack on Harman Kardon or
other compatible equipment.
§ Phono Inputs: Connect the out-
puts of your turntable or tone arm to
these jacks. Note that only Moving
Magnet (MM) type cartridges may
be used.
¶ CD Inputs: Connect these jacks
to the output of a compact disc
player or CD changer.
• Aux Inputs: Connect these jacks
to the line-level output of any audio
device such as a TV, cable converter
or portable audio player.
To Next Page
Loading...
