30
number device firmware update status -100%
Firmware update status: copying file from web finish
device firmware update status -99%
Firmware update status: Updating MCU
device firmware update status -97%
device firmware update status -94%
device firmware update status -90%
device firmware update status -70%
Firmware update status: Updating APP
device firmware update status -60%
device firmware update status -19%
device firmware update status -0%
Firmware update status: Update complete
Firmware update status: Please wait system reboot, do not power
off device
6.
reboot Reboot the
device
Command sent:
>reboot
Response:
Rebooting……
7.
reset factory Force the unit to
a factory state
(except for IP
Settings)
Command sent:
>reset factory
Response:
Resetting device to factory default parameters.
Device will automatically reboot shortly.
Do NOT power off.
8.
factoryfwimage Restore device
to factory
firmware image
Command sent:
>factoryfwimage
Response:
Are you sure you wish to reset factory parameters, and load the
factory firmware image of Version <factory image fw version> (Y/N)
->y
--Notice:it will take some time, please keep device power on--
Start restore to factory firmware image……
9.
get sn Get device serial
number
Command sent:
>get sn
Response:
Serial Number:123456789
10.
set serial
<on/off>
Set serial port on
or off
Command sent:
>set serial on
Response:
Serial port is on
To Next Page
Loading...
