Harman AMX PR-WP-412 - Output Configuration Commands

46
Configuration Commands-Output
No.
Command
Description
Variables
Example
1. get vidout
portname:<output
channel>
Get the name of the
specified output
port
<output channel>=
1~2
Command sent:
>get vidout portname:1
Response:
output 1 is named as meeting room 1
2. set vidout
portname:<output
channel>,<name>
Set the name of the
specified output
port
<output channel>=
1~2
<name= name string
Command sent:
>set vidout portname:1,Meeting Room 2
Response:
output 1 is named as meeting room 2
3. get vidout
hdcp:<output
channel>
Get HDCP mode for
the specified output
<output channel>=
1~2
Command sent:
>get vidout hdcp:1
Response:
output 1 is set to AUTO HDCP mode
4. set vidout
hdcp:<output
channel>,<hdcp_m
ode>
Set HDCP mode for
the specified output
<output channel>=
1~2
<hdcp_mode=
{
AUTO,
HDCP2.2,
HDCP1.4,
NO-HDCP
}
Command sent:
>set vidout hdcp:1,hdcp2.2
Response:
output 1 is set to HDCP2.2 mode
5. get vidout res Get video resolution
for the specified
output
<output channel>=
1~2
Command sent:
>get vidout res:1
Possible response message includes:
▪ output 1 resolution is 1280x720p,50
▪ output 1 resolution is no signal
6. set vidout
res:<resolution>
Set video solution
for the specified
output; it will
change to manual
scaling mode
automatically if
under Auto scaling
mode
<resolution>=
<H>x<V<i/p>,<Rate>
<Specific Info>
{
640x480p,60
720x480p,60
720x576p,50
800x600p,60
1024x768p,60
1280x720p,50
1280x720p,60
1280x768p,60
1280x800p,60
Command sent:
>set vidout res:1,4096x2160p,60
Possible response message includes:
▪ output resolution is set to 4096x2160p,60
▪ unsupported resolution