31
11.
get baud Get serial port
current
communicate
parameters
Command sent:
>get baud
Response:
--Current serial setting--
baud rate:9600
data bit:8
parity:none
stop bit:1
12.
set baud Set serial port
communicate
parameters
Command sent:
>set baud
Response:
--Serial port setting--
Enter baud
rate(115200,57600,38400,19200,9600,4800,2400):115200->115200
Enter data bit(8 or 7):8->8
Enter parity (E for Even, O for Odd, N for none):N->O
Enter stop bit (1 or 2):1->1
--You have entered:
Baud rate:115200
Data bit:8
Parity:odd
Stop bit:1
Would you like to save the new settings? Y/N ->y
New settings were saved
>--Current serial port baud rate: 115200
>--Current serial port data bit: 8
>--Current serial port parity: odd
>--Current serial port stop bit: 1
13.
get key lock Get front panel
key lock state
Command sent:
>get key lock
Response:
--Current key lock level state:off
14.
set key lock Set front panel
key lock level, all
for lock all front
panel key
button, menu
for only lock
menu key button
Command sent:
>set key lock
Response:
--Front panel key lock level Setting--
Enter key lock level (All for all key button, Menu for only menu
button, Off for no key button) ->menu
Key lock is set to menu
To Next Page
Loading...
