35
to auto, 100full or
10 half
>set ethernet mode
Response:
Current ethernet mode : auto
Enter new ethernet mode(Auto, 100 full or 10 half)
->10 half
--Warning: When setting ethernet mode to 10 half, it
must reset device to factory default if need change
etherment mode to be Auto/100 full.--
Would you like to set the ethernet mode (y/n):y
New ethernet mode set, reboot the device for the
change to take effect.
>--Current ethernet mode : 10 half
9.
renew dhcp Renew the DHCP
lease (may cause
telnet
disconnection)
Command sent:
>renew dhcp
Response:
You may need to re-establish the telnet session since
the device will re-acquire an IP address lease.
>--Current IP Address: 0.0.0.0
>--Current Subnet Mask: 0.0.0.0
>--Current Gateway IP: 0.0.0.0
>--Current Domain Name: cypress.local
>--Current DNS Entry 1: 10.10.10.5
>--Current DNS Entry 2: 10.10.10.2
>--Current DNS Entry 3: 0.0.0.0
>--Current IP Address: 192.168.5.149
>--Current Subnet Mask: 255.255.255.0
>--Current Gateway IP: 192.168.5.254
>--Current Domain Name: www.amx.com
>--Current DNS Entry 1: 8.8.8.8
>--Current DNS Entry 2: 8.8.4.4
>--Current DNS Entry 3: 9.9.9.9
To Next Page
Loading...
