Harman AMX PR-WP-412 - Page 48

48
set osd on for video output
11. get vidout osd color Get osd color setting
for video output
Command sent:
>get vidout osd color
Response:
get osd color set to blue
12. set vidout osd
color:<color>
Set osd color setting
for video output
<color>= black/blue
Command sent:
>set vidout osd color:blue
Response:
set osd color to blue
13. get vidout osd pos Get osd position for
video output
Command sent:
>get vidout osd pos
Response:
get osd pos set to top left
14. set vidout osd
pos:<position>
Set osd position for
video output
NOTE: The
command is to set
OSD Info position in
Windowing
Processor, not OSD
Menu position in
PR-WP-412
<position>=
{
TR (Top Right),
TL (Top Left),
BR (Bottom Right),
BL (Bottom Left),
C (Center)
}
Command sent:
>set vidout osd pos:tr
Response:
set osd pos to top right
15. get vidout cec
power:<output
channel>
Get current power
status from the sink
via CEC
<output channel>=
1~2
Command sent:
>get vidout cec power:1
Possible response message includes:
▪ get cec on for sink on output 1
▪ get cec fail for sink on output 1
▪ No attached sink
16. set vidout cec
power:<output
channel>,<state>
Set power status
on/off for the sink
device via CEC
<output channel>=
1~2
<state>=on/off
Command sent:
>set vidout cec power:1,on
Possible response message includes:
▪ set cec on for sink on output 1
▪ No attached sink
17. set vidout cec
standby:<output
channel>
Set power standby
for the sink device
via CEC on specified
output port
<output channel>=
1~2
Command sent:
>set vidout cec standby:1
Possible response message includes:
▪ set cec standby for sink on output 1
▪ No attached sink
18. set vidout cec
makeactive:<outpu
Make active for the
sink device via CEC
<output channel>=
1~2
Command sent:
>set vidout cec makeactive:1
Possible response message includes: