Harman crown DSi Series - System Wiring Configurations

DSi Series Power Amplifiers
2 Setup (continued)
2.7 Wire Your System
2.7.1 Dual Mode
Typical in p ut and output wiring is shown in Figure 2.7.
INP UT S: Connect input wiring for both channels.
Non-touch cover: Located over the amplifier output term i nals,
this included accessory provides a shock-proof cover for the
output terminals. Remove the screw holding the cover onto the
amplifier back pane l, and remove the cove r. Keep the screw.
Non-touch cover
Tab A
OUTPUTS: Maintain proper polarity(+/-) on output connectors.
Connect Channel 1 loudspeaker's positive(+) lea d to Channel 1
positive (red) terminal of amp; repeat for negative(-) Repeat
Channel 2 wiring as for Channel 1.
Figure 2. 8 Interi or of Non-T ouc h Cover
T he non-touch cover has two tabs A and B (Figure 2.8). Insert tab
A into the slot just to the left of the output terminals (Figure 2.9).
Put the screw through tab B, and screw it into the hole just to the
right of the output terminals (Figure 2.9).
Figure 2. 7 System Wiring, Dual Mod e
• . *......... 11 •
uu~u <CJo
,.. I•.• I !
Ill ' . ... .... = DSi
- c @ CE ; Cl "-S<•--s--
• - .
Operation Manual
~CITJtun ·
'8/ •v HARMAN
Tab A
Non-touch cover
Tab B
Figur e 2.9 Non-Touch Cover Positioned
Over Output
page9