2
IMPORTANT SAFETY INSTRUCTIONS 
For all products:
1.   Read these instructions.
2.   Keep these instructions.
3.   Heed all warnings.
4.   Follow all instructions.
5.   Do not block any ventilation openings. Install this apparatus 
in accordance with the manufacturer’s instructions.
6.  Do not install this apparatus near any heat sources such as 
radiators, heat registers, stoves or other apparatus (including 
ampliers) that produce heat.
7.   Do not defeat the safety purpose of the polarized or grounding-
type plug. A polarized plug has two blades with one wider 
than the other. A grounding-type plug has two blades and 
a third grounding prong. The wide blade or the third prong 
is provided for your safety. If the provided plug does not t 
into your outlet, consult an electrician for replacement of the 
obsolete outlet.
8.   Protect the power cord from being walked on or pinched, 
particularly at plugs, convenience receptacles and the point 
where they exit from the apparatus.
9.   Use  only  attachments/accessories  specied  by  the 
manufacturer.
10. Use only with the cart, stand, tripod, bracket or 
table specied by the manufacturer or sold with 
the apparatus. When a cart is used, use caution 
when moving the cart/apparatus combination 
to avoid injury from tip-over.
11. Unplug this apparatus during lightning storms or when 
unused for long periods of time.
12. To disconnect this apparatus from the AC mains completely, 
disconnect the power-supply cord plug from the AC 
receptacle.
13. The mains plug of the power-supply cord shall remain readily 
operable.
14. Do not expose batteries to excessive heat such as sunshine, 
re or the like.
15. This apparatus is intended to be used only with the power 
supply and/or charging cable provided by the manufacturer.
Caution FCC and IC statement for users (USA and Canada 
only)
This device complies with part 15 of the FCC Rules. Operation 
is  subject to  the  following  two  conditions: (1)  This  device  may 
not cause harmful interference, and (2) this device must accept 
any interference received, including interference that may cause 
undesired operation.
CAN ICES-3(B)/NMB-3(B) 
Federal Communication Commission 
Interference Statement
This equipment has been tested and found to comply with the limits 
for a Class B digital device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment 
generates, uses and can radiate radio frequency energy and, if 
not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning 
the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:
•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment into an outlet on a circuit different 
from that to which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for 
help.
Caution:  Changes  or  modications  not  expressly  approved 
by HARMAN could void the user’s authority to operate the 
equipment. 
For Products That Transmit RF Energy
FCC AND IC INFORMATION FOR USERS
This device complies with Part 15 of the FCC rules and Industry 
Canada  license-exempt  RSS  standard(s).  Operation  is  subject 
to the  following two conditions:  (1) This device  may not  cause 
harmful  interference;  and  (2)  this  device  must  accept  any 
interference received, including interference that may cause 
undesired operation.
FCC/IC Radiation Exposure Statement
This equipment complies with FCC/IC RSS-102 radiation 
exposure limits set forth for an uncontrolled environment.
FCC Caution:
High power radars are allocated as primary users of the 5.25 to 
5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations 
can cause interference with and/or damage this device. No 
conguration controls are  provided for this  wireless equipment 
allowing any change in the frequency of operations outside the 
FCC grant of authorization for US operation according to Part 
15.407 of the FCC rules.
IC Caution:
User should also be advised that:
(i) The device for operation in the band 5150-5250 MHz is only 
for indoor use to reduce the potential for harmful interference to