Harman JBL-R4500 - Page 9

General Operation (SETUP)
2- 3 Bluet ooth Settings
Press SEL knob while in BT mode to enter
Bluetooth settings . Turn VOL knob to select
sub- features, then turn VOL knob to adjust
the level of each sub-features .
AUTO CONNECT: If you don 't want to auto
connect to last paired ph one , just set Au to
Connect to OFF. It will default at ON .
DEVICE NAME : R4500 . Sel ect correct Device
BLUETOOTH SETTINGS
DEVICE NAME OFF
ON
Name when you search for Bluetooth connection on your phone .
2- 4. About
Press SEL knob at ABOUT being highlighted , it will
show the firmware information of the product .
With firmware info r mation being displayed, press
and hold the VOL knob for more th an 5 seconds
to display Factory Reset. Press SEL knob to
confirm, the unit will be initialized and restarted .
Note : Once Factory Reset is car r ied out, prior
presets will be cleared , and you will n eed to setup
the features and Global Presets once again .
8
A
Factory Reset!
- -