Harman JBL-R4500 - Page 8

General Operation (SETUP)
L OUDN ESS: OFF, ON.
AUDIO SETTINGS
LOUDNESS
SUB LE VEL: At Sub Level, turn VOL knob to toggle
amongst ZONEl, ZONE2 , or ZONE3 and push SEL
knob at desired zone; turn VOL knob again to adjust
the Sub Level from Minimum Oto maximum 15 .
ZONE1 ZONE2 ZONE3
2- 2. System Settings
Press SEL knob at SYSTEM being highlighted to
enter System Settings .
Press VOL knob to select sub-features , then turn
VOL knob to adjust the level of each sub- features .
0
I
7
SYSTEM SETTINGS
BRIGHTNESS
I-VOL
BEEP
REGION
3
I
15
BRIGHTN ESS: This feature controls the brightness of the display panel. It is adjustable
from Oto 7.
I- VO L: This feature controls the initial volume level of next power on . Turn the knob to
adjust volume level (0-45) in any playing status .
7
If the volume is set less than I- VOL, it will memorize the volume set after restarting
the un i t. If the volume is set higher than I- VOL , it will memor ize the I-V OL afte r
restarting the unit.
BEEP: This feature controls the beep sound when button was pressed.
BEEP ON : You can hear the beep sound each time you press the buttons .
BEEP 2ND : You will only hear the beep sound when the buttons are held down for more
than 2 seconds .
BEEP OFF: You will not hear the beep sound when you press the buttons .
REGI ON : The Tuner Regi on is optional for EURO, USA, JAPAN .
(Note : with wrong Regi on selected, the tuner reception might be affected .)
7