Harman SoundCraft Vi3000 - Page 59

Vi3000 USER MANUAL
®
6.5.3 6.5.3: INPUT CHANNEL > DYNAMICS > GATE
®
Vi3000 USER MANUAL
6.5.3: INPUT CHANNEL > DYNAMICS
Gate Release
Time Field / Group: REL Range Low Range High
Adjust the Gate Release
Time
This is the time an activated gate will will take to open,
from its 'hold' state.
2.2 mS 3.7 Sec
Gate Range Field / Group: RNG Range Low Range High
Adjust the Gate Range.
This is the difference between the nomral signal level
and the gated signal level.
-60dB 0dB
Gate Side
Chain Solo Field / Group: RNG Inactive Active
Switches the Gate Side
Chain signal to the Solo
buss.
For monitoring the signal being used as the gate 'key'
(The signal used for testing gate threshold).
Off Solo
Lo Cut
Frequency Field / Group: LO CUT Range Low Range High
Adjust the cut-off
frequency of the gate
sidechain lo-cut lter.
Together with the gate hi-cut lter, this creates a band-
pass lter for side chain control of the gate.
20Hz 20kHz
Sidechain Filter
In Field / Group: LO CUT Inactive Active
Inserts the gate Hi and
Lo Cut side chain lters
into the side chain
singal path.
Together the gate lo-cut and high-cut side chain lters,
create a band-pass lter for side chain control of the
gate.
Out In
Gate Hi Cut
Filter Field / Group: Hi CUT Range Low Range High
Adjust the cut-off
frequency of the gate
sidechain hi-cut lter.
Together with the gate lo-cut lter, this creates a band-
pass lter for side chain control of the gate.
20Hz 20kHz
Gate External
Key In Field / Group: HI CUT Inactive Active
Swtiches the sidechain
key signal from the main
channel signal, to an
external signal.
Assign the key input patch with the key assign button in
the MODE eld.
Out In