Revision C • 1/04
HARRIS CORPORATION
1-5
1 General Information
di
ital
Dynamic Range
Analog Input to Analog Output: 105 dB referenced to
FSD, 108 dB “A” weighted to FSD
Analog Input to Digital Output: 109 dB referenced to
FSD
Digital Input to Analog Output: 107 dB referenced to
FSD, 110 dB “A” weighted to FSD
Digital Input to Digital Output: 138 dB
Equivalent Input Noise
Microphone Preamp: -127 dBu, 150 ohm source
Total Harmonic Distortion + Noise
Mic Pre Input to Mic Pre Output: <0.005%, 20 Hz to
20 kHz, -38 dBu input, +18 dBu output
Analog Input to Analog Output: <0.005%, 20 Hz to
20 kHz, +18 dBu input, +18 dBu output
Digital Input to Digital Output:
<0.00016%, 20 Hz to
20 kHz, -20 db FSD input, -20 db FSD output
Digital Input to Analog Output:
<0.005%, 20 Hz to
20 kHz, -6 db FSD input, +18 dBu output
Crosstalk Isolation
Program-to-Program or to-Utility or to-Send:
>95 dB,
20 Hz to 20 kHz
A Input to B Input, B Input to A Input:
>110 dB, 20 Hz
to 20 kHz
Stereo Separation
Analog Program Outputs:
>86 dB, 20 Hz to 20 kHz
Console Power Requirements
Fully configured BMXdigital 22: 250 watts at 115/
230 VAC, ±12%, 50/60 Hz
Fully configured BMXdigital 30: 285 watts at 115/
230 VAC, ±12%, 50/60 Hz
Fully configured BMXdigital 38
:
320 watts at 115/
230 VAC, ±12%, 50/60 Hz
Power Supply Voltage
Console power: +48 VDC at 6.25 Amps,
optional redundant supply can be added with
48 volt coupler
Power Supply Ground
Rack mounted power supply: grounded thru AC cord
Power Supply Connection
AC input: IEC power cord, one per plug-in power
supply
DC output: Keyed multi-pin connectors
Dimensions
BMXd-8: 9.8" [249] x 29.2" [742] x 33.4" [848]
BMXd-14: 9.8" [249] x 42.0" [1067] x 33.4" [848]
BMXd-22: 9.8" [249] x 54.8" [1392] x 33.4" [848]
BMXd-30: 9.8" [249] x 67.6" [1717] x 33.4" [848]
BMXd-38: 9.8" [249] x 80.4" [2042] x 33.4" [848]
48V Power Supply (Rack mount): 2 RU: 3.5" [89] x
19" [483] x 10" [254]
48V Coupler (Rack mount): 1 RU: 1.75" [45] x 19"
[483] x 10" [254]
All dimensions are Height, Width, Depth.
Harris Corporation reserves the right to change
specifications without notice or obligation.
To Next Page
Loading...