Harris BMXDIGITAL 99-1200-0 - Microphone Preamplifier Module Quick Guide

Revision C • 1/04
HARRIS CORPORATION
3-2
3 Operation
di
g
ital
MICROPHONE PREAMPLIFIER MODULE QUICK GUIDE
This module amplifies five or ten low-level (-65 to -30 dBu) microphone signals up
to line-level (+4 dBu). The BMX
digital -8 and BMX digital -14 come standard with five
mic preamps, the other frame sizes come standard with ten mic preamps.
The line-level balanced mono output from each preamplifier can jumper directly to
a Universal Input module; be routed through a patch bay; or connect to an external
line-level mic processor. The trim controls set the gain as required for each micro-
phone preamp. These are normally set during installation and should NOT be ad-
justed by the board operator.
Two Microphone Preamplifier modules may be installed in a BMX
digital frame to
yield twenty microphone preamplifiers.
MIC PREAMPS
Remove the security cover to access the individual preamp gain trim pots. These adjust
the preamp gain to yield a nominal +4 dBu output for microphone input levels between
-65 dBu and -30 dBu.
PREAMP GAIN — PREAMP GAIN —
PREAMP GAIN — PREAMP GAIN —
PREAMP GAIN — Separate trim controls for each microphone preamp.