Harris BMXDIGITAL 99-1200-0 - Remote Line Selector (RLS) Module Quick Guide

Revision C • 1/04
HARRIS CORPORATION
3-11
3 Operation
di
g
ital
REMOTE LINE SELECTOR (RLS) MODULE QUICK GUIDE
This module has one input from a Switcher (VistaMax System, External RLS or Router).
It has the same features as the Universal Input module, except that a Source Selector
and Take button replace the A/B Input selector buttons. A limited-feature version is also
available, which does not have the Send and Utility bus controls.
SEND & UTILITY BUSES
This section has the selectors for the four Utility outputs and the two Send. Refer to page
3-4 for their functions.
PROGRAM BUSES
This section has the selectors for the four Program outputs and the two off-line buses.
Refer to page 3-5 for their functions.
MODE/PAN/BAL
This section has the controls for setting the module’s mode (stereo or mono) and the
pan or balance of the module’s bus outputs. Refer to page 3-5 for their functions.
FADER SECTION
This section has the Input Source Display, the controls for input Source Selection, the
Solo, Cue, On and Off buttons, and the module fader.
Input SInput S
Input SInput S
Input S
ourour
ourour
our
cc
cc
c
e De D
e De D
e D
isplaispla
isplaispla
ispla
y — y —
y — y —
y — A two-line ten-character display that shows the current
source (SAT_FEED) in the top line. The bottom line shows the selected source (NEWS_1).
The brackets on the current name indicate that the router source change is still pending.
See Appendix B for details on router control functions.
SS
SS
S
ourour
ourour
our
cc
cc
c
e Se S
e Se S
e S
elecelec
elecelec
elec
tt
tt
t
or — or —
or — or —
or — A rotary encoder that scrolls through the available sources
(shown in the Display’s bottom line) when the module is set as a switcher. Used with the
Take button (see below).
TT
TT
T
AKE — AKE —
AKE — AKE —
AKE — Press to take the selected source shown in the display’s bottom line. It then
becomes the current source, and is thus shown in both lines. The Take button and
Source Selector are only active with a Switcher input. For details, see page 2-25.
SOLSOL
SOLSOL
SOL
O — O —
O — O —
O — When lit, adds the module’s post-fader audio to the Solo bus and interrupts
the monitor and operator headphone outputs, but does not affect the on-line signal, the
co-host or guest outputs. Solo can be a momentary or a latched function. See page
2-33 for details.
CUE — CUE —
CUE — CUE —
CUE — When lit, routes the module’s pre fader, pre switch audio to the Control Room
module’s cue output. This does not affect the on-line signal.
ON — ON —
ON — ON —
ON — When pressed, turns the module on, lighting the button and routing the module
audio to the selected buses. Logic control commands (timer reset, start pulse, Cue reset,
etc.), may be initiated, depending upon the SETUP DIP switch settings.
OFF — OFF —
OFF — OFF —
OFF — When pressed, turns the module off, removing the module audio from all
selected buses (except those that are set for pre-switch operation). Logic control
commands (Stop Pulse, Off Tally, etc.) may be initiated, depending upon the SETUP
DIP switch settings.