Harris BMXDIGITAL 99-1200-0 - Control Room Module Connectors

Revision C • 1/04
HARRIS CORPORATION
2-34
2 Installation
di
g
ital
CONTROL ROOM MODULE CONNECTORS
Thirteen connectors come standard on each Control Room module: five 6-pin analog audio input
connectors, six 6-pin analog audio output connectors, one 14-pin logic connector, and one 8-pin logic
connector. The connectors are hidden by the meter panel in normal operation.
AUDIO INPUTS
EXEX
EXEX
EX
T-1,T-1,
T-1,T-1,
T-1,
EX EX
EX EX
EX
T-2,T-2,
T-2,T-2,
T-2,
EX EX
EX EX
EX
T-3,T-3,
T-3,T-3,
T-3,
EX EX
EX EX
EX
T-4,T-4,
T-4,T-4,
T-4,
CUE IN — CUE IN —
CUE IN — CUE IN —
CUE IN — These 6-pin analog inputs
accept stereo or mono signals from external monitor sources such as off-
air tuners, a synthetic air monitor, VistaMax monitor output, etc. When a
mono source is connected, parallel the signal to the left and right inputs.
AUDIO OUTPUTS
MONITMONIT
MONITMONIT
MONIT
OR,OR,
OR,OR,
OR,
OPER OPER
OPER OPER
OPER
AA
AA
A
TT
TT
T
OR,OR,
OR,OR,
OR,
CO-HOST CO-HOST
CO-HOST CO-HOST
CO-HOST
,,
,,
,
GUEST GUEST
GUEST GUEST
GUEST
,,
,,
,
CUE CUE
CUE CUE
CUE
,,
,,
,
TALKBTALKB
TALKBTALKB
TALKB
AA
AA
A
CKCK
CKCK
CK
——
——
— The 6-pin analog outputs for the control room monitor speaker amplifier
(Monitor); three outputs for the headphone amplifiers for the board operator
(Operator), co-host or host (Co-host) and for one or more guests (Guest); a
Cue amplifier feed (Cue); and a separate Talk to Control Room output
(Talkback) for a powered Talkback monitor speaker or amplifier.
LOGIC I/O
LL
LL
L
OGIC —OGIC —
OGIC —OGIC —
OGIC — This 14-pin connector has four “relay” outputs (Control Room
warning, mute, dim, and talkback) and two remote inputs (Dim and
Mute). See pages 2-36 and 2-37 for details on these signals.
CUE CNTL —CUE CNTL —
CUE CNTL —CUE CNTL —
CUE CNTL — This 8-pin connector has an external cue control input
See page 2-38 for details on this signal.
Right High (+)
Right Low (-)
Shield
Left High (+)
Left Low (-)
Shield
High (+)
Low (-)
Shield
Analog Inputs / Outputs - Stereo
3
2
1
6
5
4
(wire insertion end view)
Analog Inputs - Mono
High (+)
Low (-)
Shield
3
2
1
6
5
4
(wire insertion end view)