Harris BMXDIGITAL 99-1200-0 - Session Module

Revision C • 1/04
HARRIS CORPORATION
3-13
3 Operation
di
g
ital
TIMER CONTROL
This section has the controls for the event timer, located
at the right end of the meter panel.
AA
AA
A
UTUT
UTUT
UT
O RESET — O RESET —
O RESET — O RESET —
O RESET — When lit, allows the timer to be
automatically reset whenever an input module, with its
timer reset function enabled, is turned on. When a reset
command is detected, the timer resets to 00:00.0 and
immediately starts counting upward. When inactive (not
lit), the timer ignores module timer reset commands.
RESET — RESET —
RESET — RESET —
RESET — Manually resets the timer to 00:00.0. If the
timer was already counting, the timer will continue to
count up from 00:00.0.
HOLD — HOLD —
HOLD — HOLD —
HOLD — When pressed and held, stops the timer’s
display to show the elapsed time (the timer itself continues
to run). Releasing HOLD returns the timer display to the
current run time.
STST
STST
ST
ARAR
ARAR
AR
T — T —
T — T —
T — Immediately starts the timer from the
displayed time.
STST
STST
ST
OP — OP —
OP — OP —
OP — Immediately stops the timer. The elapsed time
remains on the timer display until cleared by the RESET
button, or START is pressed to start the timer counting
up from the displayed time.
Session Module