Revision C • 1/04
HARRIS CORPORATION
2-50
2 Installation
di
ital
QUICK GUIDE TO THE OUTPUT 1 MODULE
Fifteen connectors come standard on the Output 1 module: seven 6-pin analog audio output connec-
tors, seven 3-pin digital audio output connectors, and one 8-pin logic connector. The connectors are
hidden by the meter panel in normal operation.
MIX-MINUS AUDIO OUTPUTS
ANALANAL
ANALANAL
ANAL
OG —OG —
OG —OG —
OG — The 6-pin analog outputs are wired using the standard
pinout sequence. All mix-minus analog outputs are MONO audio outputs
with a fixed level of +4 dBu. The left output includes talkback; the right
output is a “clean mono feed” that does not have talkback. For more
information on the composition of this signal pair, see page 3-8 and 3-9.
DIGITDIGIT
DIGITDIGIT
DIGIT
AL —AL —
AL —AL —
AL — The 3-pin digital outputs send AES-3 (AES/EBU) compatible
signals. The left channel contains the mono mix-minus audio plus talkback;
the right channel is a “clean mono feed” that does not have talkback. The
sample rate (48 kHz or 44.1 kHz) for each output is set independently by
the SAMPLE RATE DIP switches.
TELCO RECORD MIX
AA
AA
A
nalonalo
nalonalo
nalo
g Output —g Output —
g Output —g Output —
g Output — The 6-pin analog output is wired using the standard
pinout sequence. The left channel has those Telco/Codec modules that have
TO REC active; the right channel has the base record mix. For more
information on the composition of this signal pair, see pages 3-8 and 3-9.
Digital Output —Digital Output —
Digital Output —Digital Output —
Digital Output — The 3-pin digital output is an AES-3 (AES/EBU)
compatible signal. The left channel has those Telco/Codec modules that have
TO REC active; the right channel has the base record mix. The sample rate
(48 kHz or 44.1 kHz) is set using SAMPLE RATE DIP switch 7.
PRODUCER IFB LOGIC
PP
PP
P
rr
rr
r
oo
oo
o
ducduc
ducduc
duc
er IFB Ler IFB L
er IFB Ler IFB L
er IFB L
oo
oo
o
gic —gic —
gic —gic —
gic — The 8-pin Producer IFB logic connector controls
talkback from the Producer to the Mix-Minus outputs. For more information,
see pages 2-52 and 2-53.
Digital Outputs
High (+)
Low (-)
Shield
(wire insertion end view)
3
2
1
Analog Outputs
Right High (+)
Right Low (-)
Shield
Left High (+)
Left Low (-)
Shield
3
2
1
6
5
4
(wire insertion end view)
To Next Page
Loading...