Harris BMXDIGITAL 99-1200-0 - Page 78

Revision C • 1/04
HARRIS CORPORATION
2-66
2 Installation
di
g
ital
# Switch Name ON Function (set to operator’s left) OFF Function (set to operator's right)
1 Spare Switch
2 CR Mute Mutes C/R speakers at module on
1
No monitor muting
3 Studio 1 Mute Mutes Studio 1 speakers at module on
1
No monitor muting
4 Studio 2 Mute Mutes Studio 2 speakers at module on
1
No monitor muting
5 External Site Mute Mutes external site speakers at module on
1
No monitor muting
6 Spare Switch
7 Spare Switch
8 Spare Switch
Net-Only Universal Input Module: DS1 Switch Definitions
# Switch Name ON Function (set to operator’s left) OFF Function (set to operator's right)
1 Spare Switch
2 Spare Switch
3 Spare Switch
4 Spare Switch
5 Spare Switch
6 Spare Switch
7 Spare Switch
8 Spare Switch
Net-Only Remote Line Selector (RLS) Module: DS1 Switch Definitions
# Switch Name ON Function (set to the operator’s left) OFF Function (set to the operator's right)
1 Set Telco ID Sets the module as Telco / Codec #1
1
Off
2 Set Telco ID Sets the module as Telco / Codec #2
1
Off
3 Set Telco ID Sets the module as Telco / Codec #3
1
Off
4 Set Telco ID Sets the module as Telco / Codec #4
1
Off
5 Set Telco ID Sets the module as Telco / Codec #5
1
Off
6 Set Telco ID Sets the module as Telco / Codec #6
1
Off
7 O/L & Record Source Pre-fader when module is off (only when Post-fader regardless of module on/off
Session module switch 6 is set for Pre-Fader)
8 Spare Switch
Net-Only Telco / Codec Module: DS1Switch Definitions
1
Caution: Set only one of these six DIP switches to ON. This setting identifies the module, affecting signal routing and
module controls. Each Telco module in the console MUST have a unique ID setting.
NET-ONLY MODULE DIP SWITCH SETTINGS
1
These switches are only active if the VistaMax Room Code function is not being used. Set only one switch to On
to activate mic logic functions (trigger room warning command and mute monitor speakers at channel on).