Revision C • 1/04
HARRIS CORPORATION
3-5
3 Operation
di
ital
PROGRAM BUSES
This section has the selectors for the four Program buses and
the two off-line buses.
PRPR
PRPR
PR
OGROGR
OGROGR
OGR
AM 1,AM 1,
AM 1,AM 1,
AM 1,
PR PR
PR PR
PR
OGROGR
OGROGR
OGR
AM 2,AM 2,
AM 2,AM 2,
AM 2,
PR PR
PR PR
PR
OGROGR
OGROGR
OGR
AM 3,AM 3,
AM 3,AM 3,
AM 3,
PRPR
PRPR
PR
OGROGR
OGROGR
OGR
AM 4AM 4
AM 4AM 4
AM 4
— —
— —
— When lit, routes the module audio to any
combination of the Program 1, Program 2, Program 3, and
Program 4 buses. When unlit, the module audio does not
feed that bus. These outputs are always post-switch and post-
fader.
O/L 1,O/L 1,
O/L 1,O/L 1,
O/L 1,
O/L 2 (O O/L 2 (O
O/L 2 (O O/L 2 (O
O/L 2 (O
ff-Line 1,ff-Line 1,
ff-Line 1,ff-Line 1,
ff-Line 1,
O O
O O
O
ff-Line 2) — ff-Line 2) —
ff-Line 2) — ff-Line 2) —
ff-Line 2) — When lit,
routes the module audio to any combination of the Off-Line
1 and Off-Line 2 buses (which are used for building up off-
air mix-minuses). The Off-Line feeds are always pre-switch,
but whether they are pre-fader or post-fader is set for all Input
and RLS modules through a DIP switch on the Session module.
For details on setting this option, see page 2-33 (Session Module
DIP switch settings).
MODE/PAN/BAL
This section has the controls for setting the module’s mode
(stereo or three mono modes) and the pan or balance of the
module’s bus outputs.
L and R — L and R —
L and R — L and R —
L and R — These buttons set the mode (stereo or mono).
When both buttons are unlit, the module is stereo. When the L
(left) button is lit, the left input feeds both the left and right
outputs. When the R (right) button is lit, the right input feeds
both the left and right outputs. When both L and R buttons
are lit, the left and right inputs are summed into a mono
mix, which then feeds both the left and right outputs.
RR
RR
R
otarotar
otarotar
otar
y Py P
y Py P
y P
an/Ban/B
an/Ban/B
an/B
alancalanc
alancalanc
alanc
e Ce C
e Ce C
e C
onon
onon
on
trtr
trtr
tr
ol — ol —
ol — ol —
ol — Controls where the
input is placed in stereo aural space when the PAN/BAL button
is lit. On a stereo signal, it functions as a balance control.
On a mono signal (either L or R, or both, are lit), it functions
as a pan pot.
PP
PP
P
AN/BAN/B
AN/BAN/B
AN/B
AL — AL —
AL — AL —
AL — When lit, the pan/balance control is active.
When unlit, the pan/balance control does not affect the audio.
Universal Input, Telco/Codec & RLS Modules
To Next Page
Loading...