Revision C • 1/04
HARRIS CORPORATION
3-17
3 Operation
di
ital
OUTPUT 1 MODULE QUICK GUIDE
This module has the mix-minus outputs for up to six Telco modules and a telco
record output. Separate trim controls set the analog record output level and the talk-
back levels for the producer and console mics. These controls are normally set once
during installation so should NOT require adjustment by the board operator.
OUTPUT 1
Normally protected by a security cover. It has the separate trimpots for setting the Telco
Record Mix outputs and the talkback levels for the console and producer.
TELTEL
TELTEL
TEL
CC
CC
C
O RECO REC
O RECO REC
O REC
ORD MIX,ORD MIX,
ORD MIX,ORD MIX,
ORD MIX,
LEFT & RIGHT — LEFT & RIGHT —
LEFT & RIGHT — LEFT & RIGHT —
LEFT & RIGHT — Sets the analog output levels for the Telco
Record Mix output.
CC
CC
C
ONSOLE MIC LEONSOLE MIC LE
ONSOLE MIC LEONSOLE MIC LE
ONSOLE MIC LE
VEL SET — VEL SET —
VEL SET — VEL SET —
VEL SET — Sets the talkback level to the mix-minus outputs
when the TALK BACK buttons are pressed on the Telco modules.
PRPR
PRPR
PR
ODUCER MIC LEODUCER MIC LE
ODUCER MIC LEODUCER MIC LE
ODUCER MIC LE
VEL SET — VEL SET —
VEL SET — VEL SET —
VEL SET — Sets the talkback level of the producer’s microphone
on the Producer Talkback/IFB Panel (PRE99-1188) going to the mix-minus outputs.
OUTPUT 2 MODULE QUICK GUIDE
This module has the outputs for Program 1, Program 2, Utility 1, Utility 2, and
Send 1. Trim controls, for the analog outputs, set the left and right channels separately.
These controls are normally set once during installation so should NOT require ad-
justment by the board operator.
OUTPUT 2
Normally protected by a security cover. Separate multi-turn trimpots set the left and right
analog output levels for each bus.
PGM-1L/-1R — PGM-1L/-1R —
PGM-1L/-1R — PGM-1L/-1R —
PGM-1L/-1R — Sets the left/right output levels for the Program 1 analog outputs. Both
the Main and Aux output are affected equally.
PGM-2L/-2R — PGM-2L/-2R —
PGM-2L/-2R — PGM-2L/-2R —
PGM-2L/-2R — Sets the left/right output levels for the Program 2 analog outputs. Both
the Main and Aux outputs are affected equally.
UTL-1L/-1R — UTL-1L/-1R —
UTL-1L/-1R — UTL-1L/-1R —
UTL-1L/-1R — Sets the left/right channel output levels for the Utility 1 analog output.
UTL-2L/-2R — UTL-2L/-2R —
UTL-2L/-2R — UTL-2L/-2R —
UTL-2L/-2R — Sets the left/right channel output levels for the Utility 2 analog output.
SEND-1L/-1R — SEND-1L/-1R —
SEND-1L/-1R — SEND-1L/-1R —
SEND-1L/-1R — Sets the left/right channel output levels for the Send 1 analog output.
To Next Page
Loading...